This plotter has been designed for space saving in mind. Although it can and often is mounted on a table, it can run directly on the floor and the entire machine can be simply picked up and stored out of the way. Even hung on a wall. For 3m(118in) wide machines this is a large saving of space. The pen up and down movement is very large to allow for uneven surfaces. Any pen up to 17mm (0.65in) diameter can be used.
Plotters do not require a vacuum to hold the material down. Hence a plotter is a much lower cost introduction to automation. You get all of the benefits of automating your business (with the exception of cutting) for a fraction of the cost of a cutter. Many of our cutter customers started with a plotter and then upgraded to a cutter.
Additional savings apply if you also require a digitiser since the digitiser can use the same rail, power supply and data cable as the plotter. You simply place the digitiser on the rail and move the data cable from the plotter to the digitiser. When finished, hang the digitiser on the wall.
Plotters do not require a vacuum to hold the material down. Hence a plotter is a much lower cost introduction to automation. You get all of the benefits of automating your business (with the exception of cutting) for a fraction of the cost of a cutter. Many of our cutter customers started with a plotter and then upgraded to a cutter.
Additional savings apply if you also require a digitiser since the digitiser can use the same rail, power supply and data cable as the plotter. You simply place the digitiser on the rail and move the data cable from the plotter to the digitiser. When finished, hang the digitiser on the wall.
The plotter package
A 1.5m(59in) x 7.2m(23.6ft) plotter including our Nesting software and either our PanelMaker software (full CAD program for designing flat patterns) or our ProSail (headsail/mainsail) software (for sail design) is USD 7,900.
Extra plotting lengths are USD 300 / 2m(6.5ft). Maximum length over 20m(65ft).
Extra plotting widths are USD 220 / 0.1m(3.9in). Recommended maximum width is 3m(118in) but slightly larger is possible.
If you currently have design software then you would also need our import module which can read DXF, HPGL and NTV files from other CAD software: USD 1,500.
For wide machines (2.5m or more) the optional pneumatic pen is recommended for even greater pen up/down movement : USD 350.
Payment options:
60% deposit, 40% 2 months after delivery
or
60% deposit, 45% in 12 months.
Delivery by DHL courier to anywhere in the world : USD 550. Machines over 2.5m wide must be sent by air freight.
Warranty: 2 years.
Money back offer: return the machine for any reason within 2 months and moneys received will be refunded (excluding courier).